Moving My Pins: THE PINWHEELER!!

I made a wheeled frame which can be used to move machines easily.

The frame is placed under the pin like this...

Next, the pin is lifted with the hand(s) on the top crossmember of the frame.

It’s hard to describe in words, but when you lift up, the frame pivots and moves to vertical. Here I’ve put my foot over the lower crossmember to stabilize it and keep it from moving. (Where’d that shadow come from?)

Next, I use c-clamps to hold the pin legs to the frame. (It was the cheapest thing to do...I’m looking at attaching clamps to the frame itself.)

And it’s ready to roll!! (The back frame is my earlier prototype, and it’s made of 2 x 4’s)